User Manual

EN
6

1. Make sure the throttle is in the off position and
turn on the transmitter.
2. Open the battery hatch on the bottom of the
aircraft and plug in the ight battery.
3. Install the ight battery into the aircraft as shown
and close the hatch.
4. Power on the aircraft.

3

2

Always disconnect the ight
battery from the aircraft when not ying to avoid
over-discharging the battery. Batteries
discharged to a voltage lower than the lowest
approved voltage may become damaged,
resulting in loss of performance and potential re
when batteries are charged.
 Keep away from the propellers.
Arm the motors
Turn Left/ Right motor spins
Throttle on (100%)
Turn Right/ Left motor spins
1. Turn the aircraft on as shown
above.
2. Turn the transmitter on.
3. Hold the aircraft so it does not
escape your control.
4. Arm the motors by rst moving
the left stick to 100% and then
back down to 0%.
5. Move the sticks on the
transmitter to ensure the
motors respond as shown.
 To check the Left and Right
turn, keep the throttle at 0% and
note which motor spins.
If the motors do not react as
shown, refer to the Binding
instructions and Troubleshooting
Guide in this manual.
 Keep away from the propellers, they will spin up
during the control test.
The Ascent
™
MTx aircraft relies on motor thrust to climb, descend and
turn. Always perform a control test before ight to ensure the motors
are working properly.