Datasheet
Table Of Contents
- Contents
- Microbot Overview
- PICAXE Programming System
- Microbot Power Supply
- BOT120 Microbot Contents List
- The Microbric Connector
- Assembly 1 - Motherboard Panel
- Assembly 2 - Battery Box
- Assembly 3 - Motor Housing
- Assembly 4 - Motors
- Assembly 5 - Wheels, Tyres and Rear Skid
- Assembly 6 - Line Tracker
- Assembly 7 - Bumper Switches
- Assembly 8 - Pen Holder, Servo and SRF005 Modules
- Fully Assembled Microbot
- Motor Trouble Shooting
- Programming Software
- Programming Cable
- Download Hard Reset
- PICAXE-20X2 Pin Connections
- PICAXE-20X2 Microbot Pinout Table (Logicator)
- PICAXE-20X2 Microbot Pinout Table (Programming Editor / AXEpad)
- Programming Example 1 - LED Eyes
- Programming Example 2 - Push Button Switch
- Programming Example 3 - Bumper
- Programming Example 4 - Piezo Sounder
- Programming Example 5 - Motors
- Programming Example 6 - Line Tracker Testing
- Programming Example 7 - Line Tracker Program
- BOT121 Microbot Sensors Pack
- Assembly 9 - Infra-red Receiver (IR RX) Module
- Assembly 10 - Infra-red Transmitter (IR TX) Module
- Using the TVR010A Infra-red TV Style Remote
- Programming Example 8 - Infra-red Receiver
- Programming Example 9 - Infra-red Transmitter
- Assembly 11 - LDR Light Sensor Modules
- Programming Example 10 - Testing LDR Light Sensors
- Programming Example 11 - Light Follower
- SRF005 Ultrasonic Range Finder
- Assembly 12 - SRF005 Ultrasonic Range Finder
- Programming Example 12 - Testing SRF005
- Programming Example 13 - Using the SRF005
- BOT123 Servo Upgrade Pack
- Assembly 13 - BOT123 Servo / SRF005 Servo Adapter
- Programming Example 14 - Using Servos
- BOT127 Line Tracker / LED Upgrade Pack
- Appendix 1 - Home Made Sensors
- Appendix 2 - BOT120 Microbot Motherboard Schematic
- Appendix 3 - BOT120 Sensors Schematic
- Appendix 4 - BOT121 Sensors Pack Schematic
- Appendix 5 - BOT123 Servo Pack Schematic
- Appendix 6 - Advanced PIC (Non-PICAXE) Programming
- Appendix 7 - Copyright and Trademarks
- BOT110 Versabot - Microbot's 'big brother!'
21
revolution
(c) Copyright Revolution Education Ltd. Web: www.picaxe.co.uk Version 1.1 04/10
BOT120.PMD
BOT120 PICAXE-20X2 MICROBOT
Programming Example 2 – Push Button Switch
The push button is pre-fitted to the Microbot motherboard and is
connected to input pin C.6. Reading pin C.6 will return a reading of 1
when the button is pushed and a value of 0 when it is not pushed.
The following program tests the operation of the push button by lighting
the right LED on the motherboard when the button is pushed.
Sample Logicator Flowchart File:
BOT120 PUSH SWITCH TEST.PLF
Sample BASIC File:
BOT120 PUSH SWITCH TEST.BAS
main:
if pinC.6 = 1 then
high B.3
else
low B.3
end if
goto main