User manual

Installing the Universal Spool Holders
1. Position the Spool Holder Arm in its correct position -
corresponding the labels on the spool holder to the labels on the
printer frame). !
2. Insert the 3Mx12mm screws and washers into the hole. !
3. Using your 3mm hex key, screw in clockwise. Use a 20-25 in-lb
torque for each screw. !
4. Repeat for Spool Holder Arms #1, 2, and 4. !
Note that Spool Holder Arm #3 attaches to the back panel of the printer. It requires a shorter
10mm screw, washer and bolt which is included with the spool arm.
1. Hold Spool Holder Arm #3 in position and insert
the 12 mm screw and washer on the top surface
to hold the arm in place.!
2. Position the arm over the hole on the back panel
and insert the 10 mm screw and washer into the
hole and secure with a 3mm hex key.!
3. Secure the top screw by attaching a nut and
washer on the underside of the top panel of the
printer. !
4. Using the 7mm side of the combination wrench,
hold the bolt and secure the screw using the 3mm
hex key. !
Universal Spool Holder Adaptors
We created the Universal Spool Holder Adaptors so that your spool of filament, heavy or
light, can easily rotate as the printer is printing by reducing the stress caused by pulling of
the filament by the filament drive teeth. !
They can fit most filament spools and can easily be adapted to other spools on the market.
They use the preload of the spool arms to hold the spool in place which makes it that much
faster and easier to exchange filament spools. Adjust the drag of the spool feed by adjusting
the torque of the universal spool holder adaptor bolt. !
8