User manual
Quick Change Nozzle
If you find that your filament jam cannot be solved by manually pushing filament through the
heated nozzle, it is very fast and easy to switch out the clogged nozzle.!
1. Make sure your nozzle has completely
cooled before going near the hot end. !
2. Using a 3mm hex key, loosen the bolt on
the side of the hot end.!
3. The nozzle can be removed using the
tweezers or by letting it slide out once
the bolt is loose enough. !
4. Insert the new nozzle included with your
tool kit and tighten the bolt back again. !
For a dual extruder, use the two screws
beside the fan to change out the hot end
nozzle as they are more easily accessible. !
Oiling
The XYZ linear rods and Z-Axis threaded rods need to be oiled regularly (approx. every 30
hours of printing) to make sure there is no excess wear and minimal friction while printing.
The oiler provided has synthetic mineral oil which can be found in any store. !
We have provided a holder for the oiler, scraper and tweezers inside the printer frame to
make sure you don’t forget to oil the rods and any other moving parts on the printer.!
Cleaning the Glass Build Plate
The glass build plate is easily cleaned with warm water and glass cleaner if using hairspray.
Make sure that your glass build plate doesn't build up dust as it won’t be able produce an
optimal first layer. !
25