User manual

Inputting your Printer’s Unique Calibration Settings
$ Every printer we send out goes through several calibration procedures to make sure
your selected extruder is perfectly tuned to your printer. The following printer settings are
optimized to each printer: Dual Extruder Offset, Z-Height Offset, and Print Centre. These
calibrations are found on the Delivery & Manufacture Information form and need to be
entered into the MatterControl slice settings under the Settings>Printer>Extruder and
Settings>Printer>General section when Advanced settings is selected as shown.!
Note - The Z-Offset setting is used when there is a change to the height of the Glass Build
Plate - such as adding blue painters tape or any other surface which may change the height
of the build area. Refer to the instructions in the Nozzle Clearance Settings section if
changing the bed height.
13