User manual

Inserting Filament into Extruder
Once you have installed the Spool Holder Arms and Adaptors, you are now ready to insert
your filament into the extruder.!
1. Squeeze the drive lock door to the
extruder and turn the drive door lock
knob counterclockwise to open the
filament drive door. From here you can
also view the filament gear teeth. !
!
2. Trim your filament tip to make sure its
straight. Preheat the extruder to the
extrusion temperature of your filament.!
!
3. Make sure your extruder is heated to the
extrusion temperature of the filament you
are using. Insert your filament through
the top of the extruder while holding the
filament drive door open. You should be
able to feed the filament through the
extruder and see filament being extruded
from the heated nozzle. !
4. Close the filament drive door and turn
the drive door lock knob clockwise until
tight.!
10