Specifications

Revolution 3D Printers INFINITY 3D
8-Sep-14 23 23
plate. Adjust the coarse adjust Z-Axis stop by moving it up or down until
the nozzle has a clearance of approx 2-3 mm from the build plate. You will
need to “Auto home” each time you make an adjustment. You may need to
“Auto home” a few times if you make an adjustment upwards.
14. Repeat Steps 6-14 to level each corner.
Smooth Rods
Wipe the smooth steel rods with a clean rag or paper towel. The linear bearings
require very little lubricant. Apply a small amount of lightweight oil using needle
oiler directly to the rods.
Threaded Z-Axis Rods
Place a small amount of oil from needle oiler on the threaded rods to lubricate the
internal nut located in the x-axis mounts.
Hot End
The hot end should be kept clean of extruded plastic by removing melted plastic
strands with the tweezers. If melted plastic builds up on the hot end nozzle it can
be cleaned by gently scraping with tweezers all plastic while hot end is hot.
Electronics
The electronics case holding the RAMPS board may need to have dust blown out
occasionally. Power down the printer and use the provided 2.5MM driver to remove
the 4 M3 screws holding the lid to the enclosure. The fan is mounted to the lid and
connected to the Fan Extender board. Be careful with the fan cable during removal.
Once removed use short bursts of compressed air to blow out any dust or debris.
Plug in the lid fan paying attention to polarity and reattach the lid.
Changing nozzles
The INFINITY 3D printer ships with a standard 0.35mm nozzle size Hot-End which
allows small layer resolution and up to 0.35mm layers. Although the 0.35mm
nozzle will be perfect for most printing applications Revolution 3D Printers also
offers smaller and larger nozzle sizes.