User Manual

Tabletop Master Mute
Setting the Mute Option
Individual Muting (default)
In the default setting, each Solo microphone will mute only itself when its mute
button on the microphone is pressed. To mute all of the microphones, press
the red MUTE button on the Remote Control; all microphones will flash red
and no individual microphone can be unmuted until the remote MUTE button is
pressed again. All microphones will return to their prior state. DIP switch #5
is OFF (page 18).
Tabletop Microphone Master Mute
In addition to the Remote Control MUTE button muting all of the microphones,
the Solo Tabletop microphone MUTE button will also act as a master mute and
mute all active microphones. Pressing any Tabletop microphone MUTE button
or the Remote Control MUTE button will unmute all tabletop microphones.
All wearable and handheld adapter microphones in use will return to their prior
state. DIP switch #5 is ON (page 18).
NOTE: The Fusion system must be powered off and back on for any
DIP Switch changes to take effect.
Page 20
Set-Up Guide
Page 13
Polycom® Installation (Polycom HDX9000 shown for example)
This information is meant to be illustrative only. Consult your Polycom
Videoconferencing System Administrator Manual for specific instructions.
NOTE: Requires 2 special RCA Male to 3.5mm 3 pin connectors
Revolabs Part #07-POLHDX-01.
Step 1 Step 2
1. Plug the 3.5mm 3 pin cable into the Polycom video-station <Audio In 1 Red>,
and then plug the RCA connector on the other end into the Fusion Base
Station <Conf Out>.
2. Plug the 3.5mm 3 pin cable into the Polycom video-station <Audio Out 1
Red>, and then plug the RCA connector on the other end into the Fusion
Base Station <Conf In>.
To configure the Polycom HDX 9000 Series system:
:
Select the button from the main screen to access the System menu.
Select the System / Admin settings.
Enter the administrator password and press OK (if needed).
Select the Audio settings.
Confirm or modify the following settings:
• Input Type – Line Input
• Input Type Level – 50%
• Echo Canceller - OFF
• Line Output Mode – Fixed
• Line Output Level – 50%
• Press OK to save changes.
Revolabs Fusion™