User Manual

Safety and Regulatory Information
Please read the following information to ensure safe use of your Revolabs
system.
FCC User Information
FCC Registration Number: 0014898290
FCC ID: T5V2FUSION 8 Revolabs Fusion™ Base Station 8 microphones
FCC ID: T5V2FUSION4 Revolabs Fusion™ Base Station 4 microphones
FCC ID: T5V-01-EXEMIC Revolabs Solo™ Executive Microphone
FCC NOTICE TO USERS
Users are not permitted to make changes or modify the equipment in any way.
Changes or modifications not expressly approved by Revolabs, Inc. could void
the user’s authority to operate the equipment. To meet FCC and Industry
Canada RF radiation exposure limits for general population (uncontrolled
exposure), a minimum of 7.9 inches (20 cm) separation distance must be
maintained between the Fusion Base Station and users' and/or nearby persons'
bodies at all times. Additionally, the Fusion Base Station must not be co-located
with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This product has been found to comply with the Rules of 47 CFR Part 68 of the
Federal Communications Commission and Technical Requirements For
Connection of Terminal Equipment to the Telephone Network TIA-968-A-1, A-
2 and A-3.
Certificate Number: US:6RMBR00BNEXIATC Date: April 14, 2006
IMPORTANT NOTE: FEDERAL COMMUNICATIONS COMMISSION
(FCC) RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits for an
uncontrolled environment.
Page 26
Set-Up Guide
Revolabs Fusion™
Page 7
STEP 1: Fusion Set-Up
Hardware
Decide if want to place Fusion Base Station horizontally or vertically on a flat
surface. To set-up vertically, place the Fusion Base Station vertical stand on the
bottom of the Fusion unit. Tighten bolt into Fusion Base Station.
Fusion Base Station Placement
WARNING: Do not put Fusion Base Station behind metal doors.
If you are putting the Fusion Base Station into a cabinet with non-metal doors,
you need to use the Remote IR Sensor (part number 07-IRREMO-01) for
remote to work. (Refer to page 22)
Power
Plug AC power adapter power cord into the back of the Fusion Base Station and
into wall outlet.
Plug AC wall adapter into the power outlet and the other end into the
microphone Charger Base.
Place wireless microphones in the Charger Base, let charge overnight or at least
eight hours.
Indicator lights on the Base Station Charger Base and microphones should be lit,
verifying all units are operating.
NOTE: Wait (approximately 30 seconds) until the Fusion Base Station has
powered up and the status lights have stopped flashing, before continuing on
with next steps,