User Manual

Programming Port: DIP Switches
The Fusion Base Station factory default settings are all OFF. The left
Programming Port (#8, page 6) is end-user configurable. Programming Port (#9,
page 6) on the right is reserved for Revolabs Use Only.
NOTE: The Fusion system must be powered off and back on for any
DIP Switch changes to take effect.
OFF
ON
Transmit Power Medium
Frequency A Mode
Tabletop Master Mute
Frequency B Mode
Phone Auto Answer
Transmit Power Low
1 2 3 4 5 6
Page 18
IR Remote
Set-Up Guide
Hearing Assistance
7 8
Tandberg™ Installation (Tandberg Profile MXP shown for
example)
This information is meant to be illustrative only. Consult your Tandberg
Videoconferencing System Administrator Manual for the specific instructions.
Step 1 Step 2
1. Plug one XLR connector of Cable D, XLR to XLR, into Tandberg video-
station <Mic 1 Input> and the other XLR connector into the Fusion Base Station
Mic Level Output <XLR>.
2. Plug the black RCA connector on one end of Cable C into Tandberg video-
station <Audio Out 1>, and then plug the black RCA connector on the other end
into the Fusion Base Station <Conf In>. The other RCA connector is not used.
To configure the Tandberg system:
Select the button from the main screen to access the System menu.
Go to Audio settings
Confirm or modify the following settings:
• Input 1 - MIC
• Output 1 - ON
• Audio Leveling - OFF
• Echo Canceller and Noise Reduction (EC and NR) - OFF
Adjust the audio Input Level if necessary.
Speak into the Revolabs microphones that are connected to the audio line inputs.
The audio meter should peak at about 5 dB.
Page 15
Revolabs Fusion™