User Manual

Polycom® Installation (Polycom VSX7000 shown for example)
This information is meant to be illustrative only. Consult your Polycom
Videoconferencing System Administrator Manual for specific instructions.
Step 1 Step 2
1. Plug the red RCA connector on one end of Cable C into Polycom video-
station <Audio Out 1>, and then plug the red RCA connector on the other
end into the Fusion Base Station <Conf In>.
2. Plug the black RCA connector on one end of Cable C into Polycom video-
station <Audio In>, and then plug the black RCA connector on the other end
into the Fusion Base Station <Conf Out>.
To configure the Polycom system:
Select the button from the main screen to access the System menu.
Select the System / Admin settings.
Enter the administrator password and press OK (if needed).
Select the Audio settings.
Confirm or modify the following settings:
• Midrange Speaker - OFF
• Line Input – Audio Mixer
• Echo Canceller - OFF
• Line Output – Monitor Far Site Audio
• Press OK to save changes.
Page 12
Set-Up Guide
Phone Auto Answer
Setting Phone Answering Mode
Answer with Remote Control (default)
To answer a phone call and begin a teleconference, the user must use the
Remote Control and press the “Call” key. DIP switch #6 is OFF (page 18).
Auto Answer
To answer a phone call and begin a teleconference, the user may use the
Remote Control and press the “Call” key or the Fusion Base Station will
automatically answer the call after two rings. DIP switch #6 is ON (page 18).
NOTE: The Fusion system must be powered off and back on for any
DIP Switch changes to take effect.
Page 21
Revolabs Fusion™