User Manual

Programming Port: DIP Switches
The Fusion Base Station factory default settings are all OFF. The left
Programming Port (#8, page 17) is end-user configurable: Switches 1 and 2 are
used for transmit power settings (default high power), 3 and 4 for frequency
mode settings (default unrestricted mode), 5 for tabletop mute behavior setting
(default no tabletop master mute) and switch 6 for Auto Answer (default off).
Programming Port (#9, page 17) on the right is reserved for Revolabs Use Only.
OFF
ON
Transmit Power Medium
Frequency A Mode
Tabletop Master Mute
Frequency B Mode
Auto Answer
Transmit Power Low
1 2 3 4 5 6 7 8
Page 18
Installation Guide
Programming Ports DIP Switches Used for
Phone Answering
Setting Phone Answering Mode
Answer with Remote Control (default)
To answer a phone call and begin a teleconference, the user must use the
Remote Control and press the “answer” key. DIP switch #6 is OFF.
Auto Answer
The Fusion Base Station will answer all calls. DIP switch #6 is ON.
Page 21
Revolabs Fusion™