User Manual

Details about the Revolabs Fusion
Fusion Front Panel
The Revolabs Fusion Base Station, shown below in front and rear panel
views, manages wireless audio signal processing, and pairing between the
Revolabs microphones and the Fusion Base Station.
1. IR Remote receiver (if not in sight range of remote, page x)
2. LED indicators: Displays microphone mute and pairing states
3. Pairing Push Buttons: For pairing microphones to Base
Station (page x)
4. Power On LED/Volume indicator
Page 16
Installation Guide
Page 23
Using the Revolabs Fusion™ Charger Base
When Microphones are not in use, they should be properly inserted into
the Charger Base. It is important to ensure that the system microphones are
inserted fully in the base so that charging will occur. Features of the base are
shown in the following figure.
LED indicator — power / mute status indicator.
Charger Bay — charges up to 8 Microphones.
Power Cord Receptacle— power supply input (on rear).
The Charger Base requires 5VDC power, provided by the AC Adapter.
Plug the supplied AC adapter into an appropriate power outlet 110-240 AC, 50-
60Hz. The power LED on the Charger Base will illuminate.
Charging the Microphone Batteries
First-time use — before using the wireless microphone the first time,
charge the batteries in the microphones for eight hours (or
overnight) in the
Charger Base.
2
1
3
Revolabs Fusion™