User Manual

Using Solo Tabletop Wireless Boundary Microphones
The Solo TableTop Wireless Boundary Microphones enable multiple conference
attendees to use a single microphone.
The TableTop Wireless Microphone, shown on the following page, is designed
to provide optimum coverage when placed on a conference room table.
1. Mute button — press to mute, un-mute and pair microphone.
2. LED display — visual status for mute, un-mute, and pairing.
3. Integral grille — protects internal parts (non-removable).
4. Audio jack — accepts a 2.5mm plug
5. Charging port — docks to all Solo Charger Base
6. Rubber feet — non-slip, vibration absorbing pads.
To use the Revolabs Solo™ TableTop Microphone:
Remove the microphone from the Charger Base to turn on and automatically
mute the mic (indicated by a flashing RED LED) during placement on the
conference table.
Page 26
Installation Guide
Page 13
To
configure the Tandberg system:
Go to Audio Settings.
Set Input 1 to MIC.
Confirm that Output 1 is ON.
Disable Echo Canceller (OFF).
Turn Audio Leveling (AGC) OFF.
Adjust the audio Input Type Level if necessary.
Speak into the Revolabs microphones that are connected to the audio line
inputs.
The audio meter should peak at about 5 d
Revolabs Fusion™