User Manual

SONY INSTALLATION
Requires special cable of XLR connector to 3.5 mm phono connector.
Page 10
Installation Guide
The Adapter does not provide phantom power or bias current so it cannot be
used with condenser or electret microphones.
With the microphone attached, un-mute the Adapter by pressing and releasing
the Mute button (confirm by viewing flashing GREEN LED).
If the microphone has an on-board mute switch, this switch must also be un-muted
prior to use.
To turn the Adapter off, return the microphone unit to the Charger Base or
press and hold the Mute button for ~10 seconds until the LED turns solid RED
and release button.
Important: Always remove the microphone from the Adapter by pressing the
latch switch and separating the parts before returning the Adapter to the
Charger Base.
If the Adapter is moved too far from the Base Station (~100 feet or 30 meters)
the connection will be dropped (LED flashes all colors) and the audio will mute.
After 15 seconds the microphone will beep 5 times, and will continue beeping
every 30 seconds to indicate that it is out of range.
Move the XLR Adapter closer to the Base Station and the connection will
automatically be re-established to its original state, and the beeping will cease. If
not, the XLR Adapter will continue beeping until it
turns off in about 15 minutes.
Page 29
Revolabs Fusion™