Instruction Manual

▶ Installation

1. Please turn off the RM185-ID1 before connecting any device to it.

2. Connect adaptor cable to DC power-on on the rear side of

the RM185-ID1 then connect power cord to adaptor.

3. RM185-ID1 has 15pin VGA port.

Connect the cables properly to your DVR between VGA.

4 .Turn on your DVR and RM185-ID1.

5. Display conditions with can be adjusted by pushing control buttons

on the right side of the RM185-ID1.

6. At the user's convenience, you can adjust the display angle of

the RM185-ID1 under 25 degree to backward.

7. Please turn off the RM185-ID1 when not in use.

☞ Adjusting LCD panel angle

- Do not hold or press down on the monitor's

screen while adjusting angle since LCD

panel maybe damaged or break if severe.

- Do not lean backward excessively so that

the monitor dose not fall backwards.

- Be careful of potential damage to the stand

while adjusting angle.

25’