Instruction manual

Note: To execute the function, you should save the function (PRESET, PATTERN,

TOUR, and SCAN) first.

- HOME

Select the HOME menu and press

CTRL key. Then dome camera goes to the default

position to which the dome camera returns after an assigned period of inactivity passes.

The default position may be a Preset, Tour, Pattern or no action.

- AUTO PAN

You can execute the endless auto pan which is to turn one direction continuously by select

the Auto Pan.

RELAY OUT

This function can operate only when the relay output setup has the time in the alarm menu.

Ex)

RELAY OUT SETUP

OUT1 : ALARM

OUT2 : 1 MIN

OUT3 : ALARM

OUT4 : 5 MIN

EXIT(ESC TO EXIT)

You can select OUT2 or OUT4 and press CTRL or IRIS Open then that relay operates

during the setting time only.

3.18 Motion Setup type 1(28x, 36x model)

The motion detection function is available in the preset mode only. After you set the motion in

any preset, when you call the preset with the motion, the motion detection operates.

In the preset setup, you can set the motion setup as below.

PRESET SETUP

NUMBER : 001

TITLE : ---

CAMERA SET

DWELL : --- SEC

12345678901234567890

00 █**-----------------

02 --------------------

04 --------------------

06 --------------------

SAVE AND EXIT(ESC TO CANCEL)

AE SETUP

SAVE AND EXIT(ESC TO EXIT)

MOTION SETUP

PRESET CAMERA SETUP

FOCUS : AUTO

MOTION :OFF

To enable the motion on the preset, set MOTION to ON.

To enter the motion setup, push the joystick to right on the motion setup.