Instruction manual

FACTORY DEFAULT

ARE YOU SURE ?

CANCEL

ERASE PROGRAMMED DATA

Erase all stored data from the Flash-ROM of the selected dome camera. You will be

asked to enter ON or OFF. If you desire to erase all data then select the Erase Run,

otherwise press the

ESC key to exit without erasing. The erased data includes all

stored data (auto scan, presets, and tours….) except origin offset.

The offset value is still valid after all data is erased. The offset value can be zero with

default set of Offset origin menu.

ERASE PROGRAMMED DATA

AUTO SCAN : ON

PRESET : ON

TOUR : ON

PATTERN : ON

ALARM : ON

AREA TITLE : ON

PRIVACY ZONE : ON

CAMERA : ON

DOME SETUP : ON

ERASE

SAVE AND EXIT(ESC TO CANCEL)

PRESET FOCUS DEFAULT

This menu set the default mode of the focus when you save the preset.

PRESET FOCUS DEFAULT

FOCUS : AUTO

SAVE AND EXIT(ESC TO CANCEL)

FOCUS : AUTO/MANUAL/ONE PUSH