Instruction manual

PANNING RANGE
When the dome camera is installed near a wall, panning range can be limited by user.
PANNING RANGE SETUP
(CTRL KEY)
RIGHT LIMIT : 000.0
LEFT LIMIT : 000.0
ENABLE : OFF
SWAP : OFF
AUTO PAN : OFF
SAVE AND EXIT(ESC TO CANCEL)
1. Place the dome camera under 90 degree vertically.
2. Set the right limit by pushing the
Joystick to the right.
3. Set the left limit by pushing the Joystick to the left.
4. Set ENABLE to ON to use
To exchange the right and the left limit, set SWAP to ON.
To apply limits on the auto pan (endless panning), set AUTO PAN to ON.
NOTE: When you use the panning range, we recommend using the flip mode to AUTO. When
the flip mode is 90°, 100°, 110° or 120° and you moves over 90° vertically, the panning range
operates in opposite side.
• INITIALIZE DATA
INITIALIZE DATA
FACTORY DEFAULT
ERASE PROGRAMMED DATA
PRESET FOCUS DEFAULT
EXIT (ESC TO CANCEL)
FACTORY DEFAULT
Select the Factory Default to initialize the Data.
39