Instruction manual

3.10 Area Title

Enter a specific name on programmed angle between START and END. For the screen

below, when the camera points at an angle between 124.3

° (PAN), 30.7° (TILT) to 359.5°

(PAN), 45.4

° (TILT), ABC will be displayed on the screen.

AREA TITLE SETUP

NUMBER : 01

TITLE : ABC

START ANGLE : 124.3 30.7

END ANGLE : 359.5 45.4

SWAP : OFF

SAVE AND EXIT(ESC TO CANCEL)

NUMBER :01 - 16

TITLE :up to 12 characters.

SWAP : Swap the start point for the end point.

1 . Select the” NUMBER” and set the desired number by pushing the

Joystick left or right.

2. To edit the title, follow the procedure of the auto scan above to edit titles.

3. Select “START ANGLE”. Hold down the

CTRL key while selecting the start position using

the Joystick. Current panning position will be displayed. Release CTRL key to complete

the selection of the start position. Or Press IRIS Open then the “CTRL” displays. Move

the desired position. Press IRIS Close then the “CTRL” disappears. To adjust at the 0.1

degree interval, twist the Joystick at the pan field and the tilt field.

4. Select “END ANGLE.” Hold down the

CTRL key while moving the Joystick to select the

end position. Release the CTRL key to complete the selection of the end position.

Or Press IRIS Open then the “CTRL” displays. Move the desired position. Press IRIS

Close then the “CTRL” disappears. To adjust at the 0.1 degree interval, twist the

Joystick at the pan field and the tilt field.

5. Select “SWAP”. Set to ON, to exchange the start angle and the end angle.

6. Select Save and Exit and push the

Joystick to the right or press IRIS Open. Press ESC

or IRIS Close to exit the program without saving.