Instruction manual

3.6 Shortcut of Preset Program
After selecting the desired scene, press No. (
1 to 240), and press CTRL and PRST
subsequently. The current view will be stored to the selected preset number if the preset
number is empty. If selected preset number is not empty, “
OVER WRITE” message will be
displayed on the monitor and select the “OK” and push the
Joystick to the right to overwrite.
Example: 1 , 0 , 1 + CTRL + PRST will store current view as preset No. 101. In this case,
focus will be programmed as Auto, dwell time will be set to 3 second, and the current AE
mode will be programmed.
3.7 Tour (SHORTCUT: TOUR)
There are 8 programmable Tours. Each Tour consists of up to 42 Preset positions, Patterns,
Scans or other Tours (second-level). Using second-level tours, it can be expanded to over
300 functions in a single tour.
TOUR SETUP
NUMBER : 01
TITLE : T01
SCAN TYPE : NORMAL
SPEED : 5 STEP
DWELL : -- SEC
003 A08 --- --- --- --- ---
--- --- --- --- --- --- ---
--- --- P01 --- --- --- ---
--- T02 --- --- --- --- ---
--- --- --- --- --- --- ---
--- --- --- --- --- --- ---
SAVE AND EXIT(ESC TO CANCEL)
--- : blank position
SCAN TYPE : NORMAL/ VECTOR
DWELL : 03-99 Sec
003 : Preset (1~240)
A08 : Auto Scan (1~8,10~17)
P01 : Pattern (1~8)
T02 : Tour (1~8)
Follow the steps below to program the Tours:
1. Press
MENU to display the main menu on the monitor. Scroll to Tour and push the
Joystick to the right to enter the Tour menu. Or just press the TOUR key on the
keyboard.
2. Select the” NUMBER” and set the desired number by pushing the
Joystick left or right.
3. Choose a blank position to be programmed by pushing the
Joystick up, down, right,
or left.
4. To add a stored preset, twist the
Joystick then the stored preset number displays.
17