Instruction manual

MOTION SETUP

SENSITIVITY : 12

POSITION : ALL

DELAY : 00 SEC

OUTPUT : OFF

HOLD TIME : 03 SEC

EXIT(ESC TO EXIT)

Set SENSITIVITY: 1~10(22X model) / 1~15(36X model)

Set POSITION: ALL, CENTER

Set DELAY: 0~5 SEC

Set OUTPUT: OFF, OUT1

Set HOLD TIME: 3~99 SEC

Select “AE SETUP” and pushing the

Joystick left or right. Then the AE setup displays.

Refer to the AE SETUP in the camera setup.

6. Set “DWELL TIME”(03-99second)

7. To select the next page of presets, scroll the page by pushing the

Joystick to the Left

on the first and last columns of the menu.

8. Repeat steps 2 through 7 for each additional preset position.

9. Select Save and Exit by pushing the Joystick to the right. Press ESC to exit the Preset

menu without saving.

NOTE: Press the HOME key at programmed preset position(*) to delete a programmed preset

view.

The position, which is marked with

*, already has the preset view assigned. To review the

stored preset, press

PRST key on the *，The camera will show the stored preset scene.

PRESET AREA SETUP

(CTRL KEY)

NUMBER 001

PAN TILT

000.0 000.0

EXIT(ESC TO EXIT)

Hold down the

CTRL key while selecting the desired scene using the Joystick. Current

position will be displayed. Release CTRL key to complete. Or Press IRIS Open then the

“CTRL” displays. Move the desired position and the zoom position. Press IRIS Close then

the “CTRL” disappears. Select Exit and push the Joystick to the right.