FAQ

Q: I lost the SETTINGS TOOL that came with the CONTROL SCREW KIT, can I
use a screwdriver to make adjustments?
A: Yes. You can use any small tool, just be careful not to break the sensitivity and
timer dials.
Q: What happens if someone turns the FAN off before the room is fully dried?
A: The CONTROL knows when your room needs to be dried. If someone turns the
CONTROL off manually it will still sense the condensation and turn on again after 1
minute to finish drying the room.
Q: If I set my countdown timer to 5 minutes, does that mean that the FAN will only
run for 5 minutes when condensation is detected?
A: No. The timer is only used with manual operation. The CONDENSATION
SENSOR in the CONTROL runs based on condensation detection only and will
always run the fan as long as it takes to return the room back to its original dryness
level before the shower or bath.
Q: When the FAN is on, the CONTROL is clicking and the BLUE LED LIGHT is
turning on and off. How do I fix this?
A: The CONTROL may be wired incorrectly. Check the wiring diagram on PAGES
20-21 and ensure that the power, neutral, fan, and ground wires are connected
correctly.
Q: Can I use the CONTROL in a 3-way wiring configuration?
A: Yes, the CONTROL can be used in multi-switch and/or multi-fan configurations.
The instructions and wiring diagrams for these configurations can be found at
www.reventfans.com/wiring.
Q: I really like the CONTROL, can I order a second one separately?
A: Yes! Visit our website at www.dewstop.com to purchase more DewStop
®
Humidity and Condensation Sensing Fan Controls!
Q: I still have additional questions.
A: Contact us at [e-mail] or call our service department at
[phone]. We are happy to assist you with any additional questions.