Safety data sheet

Page 3/6
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 28.01.2014 Revision: 28.01.2014Version number 1
Trade name: Contacta Professional
(Contd. of page 2)
38.0.2
6.3 Methods and material for containment and cleaning up:
Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
Do not flush with water or aqueous cleansing agents
No special measures required.
6.4 Reference to other sections
See Section 7 for information on safe handling.
See Section 8 for information on personal protection equipment.
See Section 13 for disposal information.
SECTION 7: Handling and storage
7.1 Precautions for safe handling
No special precautions are necessary if used correctly.
Information about fire - and explosion protection:
Keep ignition sources away - Do not smoke.
Protect against electrostatic charges.
7.2 Conditions for safe storage, including any incompatibilities
Storage:
Requirements to be met by storerooms and receptacles:
No special requirements.
Information about storage in one common storage facility:
Not required.
Further information about storage conditions:
Keep container tightly sealed.
7.3 Specific end use(s)
No further relevant information available.
SECTION 8: Exposure controls/personal protection
Additional information about design of technical facilities:
No further data; see item 7.
8.1 Control parameters
Ingredients with limit values that require monitoring at the workplace:
123-86-4 n-butyl acetate
WEL Short-term value: 966 mg/m³, 200 ppm
Long-term value: 724 mg/m³, 150 ppm
Additional information:
The lists valid during the making were used as basis.
8.2 Exposure controls
Personal protective equipment:
General protective and hygienic measures:
Wash hands before breaks and at the end of work.
Respiratory protection:
Not required.
Protection of hands:
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/
the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the
resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the
application.
Penetration time of glove material
The exact break through time has to be found out by the manufacturer of the protective gloves and has to be
observed.
Eye protection:
Tightly sealed goggles
GB
(Contd. on page 4)