Certifications 2

Page 4/7
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 10.05.2021 Revision: 10.05.2021Version number 3.0
Trade name: Contacta Professional
(Contd. of page 3)
53.0
application.
Penetration time of glove material
The exact break through time has to be found out by the manufacturer of the protective gloves and has to be
observed.
For the permanent contact in work areas without heightened risk of injury (e.g. Laboratory) gloves made
of the following material are suitable:
Butyl rubber, BR
Nitrile rubber, NBR
For the permanent contact gloves made of the following materials are suitable:
Butyl rubber, BR
For the permanent contact of a maximum of 15 minutes gloves made of the following materials are
suitable:
Nitrile rubber, NBR
Chloroprene rubber, CR
Eye protection:
Tightly sealed goggles
*
SECTION 9: Physical and chemical properties
9.1 Information on basic physical and chemical properties
General Information
Appearance:
Form:
Fluid
Colour:
Colourless
Odour:
Characteristic
Change in condition
Initial boiling point and boiling range:
Undetermined.
Flash point:
26 °C
Ignition temperature:
370 °C
Explosive properties:
Product is not explosive. However, formation of explosive air/
vapour mixtures are possible.
Explosion limits:
Lower:
1.1 Vol %
Upper:
8 Vol %
Vapour pressure at 20 °C:
13 hPa
Density at 20 °C:
0.9 g/cm³
Solubility in / Miscibility with
water:
Not miscible or difficult to mix.
Viscosity:
Kinematic at 20 °C:
21 s (DIN 53211/4)
Solvent separation test:
Organic solvents:
85.0 %
VOC (EC)
765.0 g/l
9.2 Other information
No further relevant information available.
SECTION 10: Stability and reactivity
10.1 Reactivity
No further relevant information available.
10.2 Chemical stability
Thermal decomposition / conditions to be avoided:
No decomposition if used according to specifications.
10.3 Possibility of hazardous reactions
No dangerous reactions known.
10.4 Conditions to avoid
No further relevant information available.
(Contd. on page 5)
GB