Revel ® IW65/IW80 In-Wall Loudspeakers IC65/IC80/IC6T2 In-Ceiling Loudspeakers Owner’s Manual
DOCUMENTATION CONVENTIONS This document contains general safety, installation and operation instructions for the Revel® Concerta™ IW65/IW80 in-wall loudspeakers and the IC65/IC80/IC6T2 in-ceiling loudspeakers. It is important to read this document before attempting to use these products. Pay particular attention to safety instructions. WARNING! Calls attention to a procedure, practice, condition or the like that, if not correctly performed or adhered to, could result in injury or death.
ABOUT THE REVEL® CONCERTA™ IW65/IW80 IN-WALL AND IC65/IC80/IC6T2 IN-CEILING LOUDSPEAKERS Since 1996, the Revel name has stood for the best in loudspeaker design and performance.
INSTALLATION CONSIDERATIONS Loudspeaker fidelity depends on the following factors: High-Frequency-Level Control The High-Frequency-Level control allows for the fine-tuning of the tweeter output level. This three-position switch provides the listener with the ability to adjust the highfrequency range for various acoustical environments.
LOUDSPEAKER PLACEMENT The following general placement suggestions are accompanied by diagrams for recommended loudspeaker locations. IW65/IW80 IN-WALL LOUDSPEAKER PLACEMENT – 2-CHANNEL STEREO Before installing the loudspeakers, survey the listening area, keeping the following points in mind and using Figure 4 as a guide: • Place the left and right loudspeakers as close to the same distance from the primary listening area as possible, and also at an equal distance from the side walls.
Left Front Channel Right Front Channel Subwoofer (optional) Center Channel (above or below video screen) Couch Left Surround Channel Right Surround Channel Left Rear Center Rear Right Rear Channel Channel Channel Figure 6: IW65/IW80 in-wall loudspeaker placement – 6- or 7.1-channel system IC65/IC80 IN-CEILING LOUDSPEAKER PLACEMENT The placement of the in-ceiling loudspeakers depends upon the intended application. Please refer to the section below that best describes your application.
2-Channel Stereo Sound • Place the left and right loudspeakers as close to the same distance from the primary listening area as possible, and also at an equal distance from the side walls. Ideally, the distance between the left and right loudspeakers should be slightly less than their distance from the primary listening area. The distance between the left and right loudspeakers should also be the same distance as from the loudspeakers to the side walls.
CAUTION! Be sure to comply with local wiring codes. Harman International Industries, Incorporated, is not responsible for any damages or injuries that may result from faulty wiring. MAXIMUM WIRE GAUGE Gauge (AWG) Length (Feet) Length (Meters) 6 87 27 7 69 21 8 58 18 9 43 13 10 34 10 11 27 8 12 22 7 13 17 5 1. Remove the plastic paint shield from the speaker frame. Paint Shield 2.
4. Connect the speaker wires to the speaker. Ensure that the polarity of each connection is correct. 7. Attach the metal grille and logo. 5. Ensure that all four locking tabs are properly positioned against the locking-tab stops, located on the speaker frame. INSTALLATION IC65/IC80/IC6T2 IN-CEILING To add the IC65/IC80/IC6T2 in-ceiling loudspeakers to finished construction, proceed with the following instructions.
Cut the drywall along the speaker template marks made in Step 2. 4. Connect the speaker wires to the speaker. Ensure that the polarity of each connection is correct. The locking tabs will swivel into place and secure the unit to the rear surface of the ceiling panel. Hand-tighten with a nonpowered, straight-handle Phillips-head screwdriver only. Ensure that the speaker is securely held in place and that all four locking tabs are firmly resting against the ceiling material.
Painting the Speaker Frame and Grille The Revel IW65/80, IC6T2 and IC65/80 loudspeakers can be painted to match any décor. If you wish to change their color, the satin finish on the grille and frame will function as a primer coat. Follow these instructions for proper painting procedure: 1. Before beginning, carefully remove the grille (if installed), and install the supplied plastic paint shield securely into the recess in the baffle.
SPECIFICATIONS Specification IW65 Frequency Response (2π anechoic) IW80 IC65 50Hz to 40kHz, ±3dB 40 Hz to 40 kHz, ±3dB 50Hz to 40kHz, ±3dB Recommended Amplifier Power Range Sensitivity (2.
LIMITED WARRANTY A valid serial number is required for warranty coverage. This Revel warranty protects the original retail purchaser for a period of five (5) years (parts and labor) from any failure as a result of original manufacturing defects, so long as: Service will pay return shipping charges within the United States only in the event that the product is found to be defective, as mentioned above. There are other stipulations that may apply to shipping charges. 1.
Revel, the Revel logo and Concerta are trademarks of Harman International Industries, Incorporated, in the United States and/or other countries. Features, specifications and appearance are subject to change without notice. For customer service and product shipment information, go to www.revelspeakers.com. Part No. 406-000-05627-E Rev 2 ©2008 Harman International Industries, Incorporated. All rights reserved.
