HSGP1053-C10_OM 9/12/08 12:29 PM Page 1 Revel ® C10 Owner’s Manual
HSGP1053-C10_OM 9/12/08 12:29 PM Page 2 Revel Concerta , C10 Owner s Manual ® ™ Table of Contents 3 Introduction 3 Planning Your System 3 Placement 4 Wall-Mounting the C10, Using the Included Wall Bracket 6 Wiring the Speaker 6 Maintenance and Service 7 Specifications 2
HSGP1053-C10_OM 9/12/08 12:29 PM Page 3 Introduction Planning Your System Revel® Concerta™ C10 Before deciding where to best place your speakers, survey your room and study Figure 1. The Revel® Concerta™ C10 center channel speaker is designed to perfectly complement the M10 and M8 satellite loudspeakers. It uses identical drivers to provide exceptional dialogue reproduction and a seamless transition between the front channels.The horizontal design allows for maximum placement flexibility.
HSGP1053-C10_OM 9/12/08 12:29 PM Page 4 Tilting the Speaker If needed, the enclosed stand allows you to tilt the speaker across a wide range (i.e., upward to a maximum of 18° or downward to a maximum of 7°), as shown in Figure 3. Important! DO NOT exceed the tilt range. Doing so may cause the speaker to fall out of its stand.
HSGP1053-C10_OM 9/12/08 12:29 PM Page 5 Step Four Step Six Using the included Allen wrench, remove the top and bottom end caps of the speaker by unscrewing the single center screw on bottom. The wall-bracket design allows for rotation of the speakers at angles of up to 30º of center. Position the speakers so that they face toward the primary listening position, before fully tightening. End cap End cap 1/4-20 x 3/4" Screw Step Five Connect the wires (see page 6).
HSGP1053-C10_OM 9/12/08 12:29 PM Page 6 Wiring the Speaker After placing the speaker, you are ready to connect it to your system. First, turn off all audio system power. Use high-quality speaker wire to make the connections. Consult the owner’s manuals included with your amplifier or receiver for connection and operation procedures.
HSGP1053-C10_OM 9/12/08 12:29 PM Page 7 Specifications Revel® Concerta™ C10 Frequency Response (±3dB) 110Hz – 21kHz Recommended Amplifier Power Range 10 – 150 Watts Sensitivity (2.83V @ 1m, 2π anechoic) 89dB Nominal Impedance 8 Ohms Crossover Frequency 2–1/2-Way high-order at 400Hz and 2.
HSGP1053-C10_OM 9/12/08 12:29 PM Page 8 Limited Warranty service center. A valid serial number is required for warranty coverage. This Revel warranty protects the original retail purchaser for a period of five (5) years (parts and labor) from any failure as a result of original manufacturing defects, so long as: 1. The Revel products were purchased within the 50 United States, its territories or Canada. 2.
HSGP1053-C10_OM 9/12/08 12:29 PM Page 12 Revel, the Revel logo and Concerta are trademarks of Harman International Industries, Incorporated, in the United States and/or other countries. Dolby and Pro Logic are registered trademarks of Dolby Laboratories. DTS is a registered trademark of DTS, Inc. Features, specifications and appearance are subject to change without notice. www.revelspeakers.com 250 Crossways Park Drive, Woodbury, NY 11797 8500 Balboa Boulevard, Northridge, CA 91329 516.594.
