Specifications

The monitor control has a sepetate output
for nearfield monito-
ring. The Phones control has its own outputs
on the frontpanel in a
t'ecessed section close to the faders. A mute
switch cuts the very
po-
werfull headphones
amps.
The main stereo faders afe
mono audiotapr
faders and control
the
overall outgoing level coming from the main stereo mix
bussamps.
A 10
dB
gain
is available at the output
which is set to be
+4dBu
nominal.
Monitor level
The Monitot level controls the total outgoing
level to
the monitot.
When in the full cloclapise
positiorr,
a balanced
"igtul
of
+4
dBu
is
glven
out
to
the monitot amps. It is important
to have the monitot
arnps correctly
adjusted.
You should adjust
the monitor
amps
(in-
put
level controls) to an
undistorted
level with
the Monitot level
control fully clochvise.
NOTE: This alignment is imperative in order
to avoid dnmage to
the speakers,
or in
some cases, damage to the ears of the listener.
T\vo monitor Systems
The Axion has two monitorsystetns intended foruse with headpho-
nes and nearfield monitors. V/e advise that nearfield monitors be
wired to the Monitor output.
Insert stereo
The insefi switch switches the signal
processors
retums into the
main signal
path
for both left and dght outputs.
2.3 COMMT]NICATION
SEC
TION
The cornnrunication section is a very cornprehensive and
irnportarrt
part
of
the Axion console. It is
vital
in
life
perforrnances
to
be able
to
cornrnunicate
at
arty
point
during
the
show-
hrside the rnaster section of the Axion there
is a
"Clearcorn"
*ASL"
cornpatible rnaster station to feed
*Beltpack"
systerns of
either bmrrdo rnaking coil]rnunication easy.
The Talkback rnicrophone
(which
has
an
input on the frontpanel
as
well
as on the connector
panel
at
the
back
of the console) can
be
phantorn
powered
by
j,rtoper
settings
on the
board.
The
Talkback
rnic
can
be
assigned
to
the following
sections
of
the
console individually or to
all
at the sarne
tirne.
Direct output
at the
back of the
console.
Aux ouput arnps
(if
the aux enable switches
are active)
Matrix outputs
(
if
the
aux
enable switches
are active)
Group
outputs
(if
the
group
enable
switches
are active)
Mono output
Stereo output