Instructions
12
11
Volume setting/Melody selection
Press the “Volume”/”melody forward/backward” button until you hear the
required volume/melody.
You can change the volume at any time and this is independent of the
corresponding transmitter. The last selected volume is automatically saved.
You can still replay different bell tones by pressing “Melody forward/backward”.
This does not effect the saved bell tone when coding between transmitter and
receiver.
Installation
Choose a suitable location for the chime and bell push. Check the selected
location for wiring before drilling any holes.
Tip: Test the desired function before ultimately installing the device at the place
of installation you chose.
Mount the mounting plate using the enclosed screws. Push the bell push onto the
mounting plate or use the enclosed double-sided tape for mounting.
• Up to 20 receivers (chime) can be assigned to one transmitter (bell push, motion
detector, window contact). Refer to “Compatible Products”.
• Up to 20 transmitters (bell pushes, motion sensors, window contacts)
can be assigned to one receiver (chime). Refer to “Compatible Products”.
Deleting the coding:
Press the “Melody forward” button for 5 seconds, to reset the chime to the
factory settings. When the chime plays back ding-dong and the LED blinks,
resetting was successful.
Note: The coding between chime and window contact exists,
until you delete the coding as described above. Even if you remove the batteries.
battery
compartment
Push mounting
plate upwards for
disassembly.
bell push rear side
ANL_DB50.indd 11-12 25.02.2019 08:45:21