Instructions

10
9
• Do not attempt to reactivate batteries by heating or similar measures.
• Primary batteries must not be charged as this can lead to electrolyte leakage,
explosion or fire.
• Do not immerse batteries in water and store them in a dry and cool place, not in a
damp place.
• Do not throw batteries into the fire, do not open them or solder or weld them
yourself.
• Do not short-circuit batteries.
Set up
Remove the mounting plate on the rear side by pushing it off the rear side of the
bell push (see illustration on the right). Open the battery compartment of the bell
push using the enclosed screwdriver. Remove the insulation strip in the battery
compartment. Then, close the battery
compartment again.
Creating/deleting coding
Chime and bell push in this set were already coded in the factory. If you want to renew
the coding or add additional chimes/bell pushes, please proceed as follows.
Coding the chime and bell button::
1. Before coding, select your preferable bell tone (refer to “Volume setting/Melody
selection”).
2. Press the “Volume” button on the chime for 5 seconds. You will hear a ding-dong
and the LED starts blinking, to signalise that the coding mode is active.
3. Press the bell push, to send a signal to the chime. If the coding was successful, the
chime will automatically play back the bell tone.
Note:
• The coding mode is automatically terminated after concluding the coding.
• The coding mode is only active for 5 seconds.
• The coding mode is always only available for one receiver (chime) and transmitter
(bell push, motion detector, window contact) simultaneously. Repeat the
above-mentioned coding if you would like to code multiple receivers/transmitters.
• You can assign a different bell tone to each transmitter when coding and in doing so,
create a call differentiation.
General information
Please thoroughly read the following operating instructions before
placing the device into service and keep for future reference. The bell
button is suitable for operation in protected outdoor areas and not in
harsh environments. The wireless chime is intended for installation in
dry indoor areas (IP20).
Notes
• The wireless chime is only designed for use with the appropriate batteries.
• To be able to use the bell push, you will need a receiver (bell) from the
Orchestra range
• In combination with a receiver (gong), the motion detector offers you the
opportunity to set up a bell system without wiring.
• This set is not intended for integration into an existing bell system.
• The range between transmitter and receiver is maximum 100m in the open field
The radio signal is transmitted through walls, walls, furniture and other obstacles,
but depends on the structural conditions - walls, especially reinforced concrete
walls, heat-insulating glazing and ceilings lead to a reduction in range.
• Shielding caused by metal parts can severely impair reception, so that the signal
cannot be transmitted. For this reason, never attach the transmitter to metal
surfaces.
• If the product is not in use for a long period of time, remove the batteries.
• The product has no replaceable parts. Do not try to open or repair the product.
Technical Data
Range (free field): max. 150m
Frequency: 433,92MHz
Frequency band: 433,05 – 434,79MHz
Max. transmission power: <10mW
Battery: 1x 12V 23A (included in delivery)
Degree of protection: IP55, (for outdoor use only)
Degree of protection: Safety Extra Low Voltage
Safety Instructions for batteries:
• Incorrect polarity of the batteries can destroy the unit.
• Do not store batteries within reach of children, especially those that can be
swallowed.
GB
ANL_DB50.indd 9-10 25.02.2019 08:45:21