Owner's manual

Sink/Vanity Base applications
New Construction (No plumbing present)
1) Measure the inside width and depth
of your base cabinet.
Note: When measuring the depth, make
sure to include the face frame thickness.
2) To trim your Drip Tray, only a utility
knife and straight edge is required. Begin by
scoring the cut line several times and simply
break on the score line. You can also do this
using a powered saw, but is not necessary.
3) Since the Drip Tray ts over the face frame and in
most cases a center mullion, you will need to trim Drip
Tray to t ush to the front. A utility knife may be used
to make the cuts, but a power tool (jig saw, scroll saw,
etc) might give you a little more control.
4) Once tray is tted inside
cabinet, use silicon adhesive
around the entire perimeter
and any holes you made for
plumbing. Take care to seal
all the cuts to ensure a water
tight seal.