Installation & Assembly

ManualsBrandsRev-A-Shelf ManualsFacilities & MaintenanceTop Mount 12.5 Gallon Pull Out Trash Can

INSTALLATION INSTRUCTIONS

Measure the distance from the

bottom edge of the cabinet

opening to the slotted holes

(See Fig. B).

12400 Earl Jones Way

Louisville, KY 40299

rev-a-shelf.com

Customer Service: 800-626-1126

DOOR MOUNTING WORKSHEET

I-DMTMRV -0219

Once the unit is installed, door

mount the unit for easy access.

Make sure the door brackets

are lined up with the thick

portion of the cabinet door.

Measure the hole spread

between the brackets

(See Fig. A).

Note: Use provided squares

throughout the worksheet to

record each measurement.

STEP 1

Distance

to slotted

hole

locations

FIG. A

FIG. B

TOOLS REQUIRED:

Hole spread

Summary of content (4 pages)

PAGE 1
2400 Earl Jones Way Louisville, KY 40299 rev-a-shelf.com Customer Service: 800-626-1126 DOOR MOUNTING WORKSHEET FIG. A TOOLS REQUIRED: 1 8 3 8 Once the unit is installed, door mount the unit for easy access. Make sure the door brackets are lined up with the thick portion of the cabinet door. Measure the hole spread between the brackets (See Fig. A). Hole spread FIG. B Note: Use provided squares throughout the worksheet to record each measurement.
PAGE 2
FIG. C STEP 2 Measure your cabinet opening and then measure your door size. Take the difference of these two numbers and divide it by 2. This number is your door overlay or inset gap (See Fig. C). Door size Cabinet opening STEP 3 If the door is larger than the opening ADD the door overlay to the Step 1 dimensions. If the door is smaller than the opening SUBTRACT the inset gap from the Step 1 dimensions. Difference ÷ 2 (overlay or inset) Difference FIG.
PAGE 3
12400 Earl Jones Way Louisville, KY 40299 rev-a-shelf.com Customer Service: 800-626-1126 INSTRUCCIONES DE INSTALACIÓN / INSTRUCTIONS D’INSTALLATION HOJA DE TRABAJO PARA MONTAJE DE PUERTA FEUILLE DE TRAVAIL DES INSTRUCTIONS DE MONTAGE DE PORTE FIG. A Herramientas requeridas: Outils Requis: 1 8 Ahora que su producto ya está instalado querrá instalar la puerta del gabinete para un fácil acceso. Asegúrese de que los soportes de la puerta estén instalados con la porción gruesa de la puerta del gabinete.
PAGE 4
FIG. C PASO 2/ÉTAPE 2 Mida la apertura del gabinete y luego mida el tamaño de su puerta. Tome la diferencia de estos dos números y divídalo por 2. Este número es la plantilla de su puerta o espacio del recuadro. (Figura C). Tamaño de la puerta Apertura del gabinete Ouverture de l’armoire Taille de la porte Mesurez l’ouverture de votre armoire, puis mesurez la taille de votre porte. Prenez la différence de ces deux nombres et divisez-la par 2.