Instructions / Assembly

USING KEY
Use Lock Key to open cabinet door/drawer.
STEP 3
STEP 4
Open door and mark + with punch.
Measure door
thickness and
subtract 3/16”
(4.76mm) to
obtain drilling
depth.
DO NOT PEEL
No pele
Ne pas éplucher
9/32”
PEEL OFF
Pelar
Peel ici
= DOOR THICKNESS – 3/16”
STEP 5
DO NOT PEEL
No pele
Ne pas éplucher
9/32”
PEEL OFF
Pelar
Peel ici
Drill into the marked 9/32” hole location into
installation template, using caution not to drill
through the door. The hole must be clear and
free of debris.
STEP 6
Match striking plate over two locations marked
during Step 2. Use screws and install loosely so
slot adjustments can be made later.
STEP 7
Match the Lock
Assembly with
plunger to the
drilled hole. Align
with marked holes,
secure with 1/2
inch screws.
Install red unlocking bar in hole on one side with
unlock letters up. Then straddle the housing and
pop in the opposite side.
DO NOT PEEL
No pele
Ne pas éplucher
9/32”
PEEL OFF
Pelar
Peel ici
DRILLING
DEPTH
12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com | 1-800-626-1126
Made in the USA
I-RLTL-0615