Installation Instructions

INSTALLATION INSTRUCTIONS: SHELF MOUNTING WORKSHEET
12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service: 800-626-1126
SHELF MOUNTING WORKSHEET
I-MLSHELF18-1017
FIG. A
FIG. B
NOTE: Holes are pre-drilled to
ensure proper function of the
mixer lift.
From underneath, line-up the
pre-drilled holes in the shelf with
the slotted holes on the mounting
plates. Insert (6) #10 x 1/2” wood
screws into the pre-drilled holes,
but do not fully tighten.
(See Fig A).
Adjust shelf side edges so they are
over the 90-degree bend of the
mounting plate and tighten screws
(See Fig B).
Note: Shelf cannot extend
past the outer surface of the
mounting plate.
This worksheet is for installing
Rev-A-Shelf’s maple or walnut
shelves to their appropriate mixer
lift mechanisms.
Note: Mixer Lift mechanism and
screws packaged separately.
Maple shelf is 11-3/4” x 20” and
designed for 18” face frame
cabinets.
Walnut shelf is 13-1/4” x 20”
and designed for 18” frameless
cabinets.
MOUNTING THE MIXER
LIFT SHELF
STEP 1
STEP 2
From underneath attach (6)
additional #10 x 1/2” (12 mm)
wood screws to remaining
(non-drilled) hole locations to
complete installation.
STEP 3
UNDERSIDE OF
MIXER LIFT SHELF
FRONT EDGE OF
MIXER LIFT SHELF
3” (76 mm)
3” (76 mm)
8-1/2”
(216 mm)
1-3/16”
(30 mm)
20” (508 mm)
PRE-DRILLED HOLE
LOCATIONS
Mounting plate
outer surface
90° bend
Maple is 11-3/4”(298 mm)
Walnut is 13-1/4” (337 mm)

Summary of content (2 pages)