Instructions / Assembly

1 of 4

Installation instructions for:

Article # 60-9168-8 (white) / 60-9268-8 (almond)

System 9

Pie-cut

Doors revolving

90-degree corner

Tray diameter: 24" (60 cm)

Mounting height: 27 1/4" - 29 1/4"

(69 - 74 cm)

Minimum cabinet dimensions:

EURO : 72 cm

a = 72 cm

b = 47 cm

c = 25 cm

USA : 28"

a= 28"

b= 18"

c= 10"

You have purchased the finest carousel product available, the

Lazy Daisy

Susan. For any questions or further information,

please contact us at:

Congratulations!

Base Cabinet

28" x 28"

72 x 72 cm

1255 South Park Dr., Kernersville, NC 27284, USA

Telephone 336-996-7774, 1-800-222-6941, Fax 336-996-1812

Website: www.petermeier.com Email: info@petermeier.com

)8-8629-06( )8-8619-06( syarT )2( TUC-EIP ni42

9.24

LD-I-9-24-R

Article # LD-60-9168-8 (white) / LD-60-9268-8 (almond)

12400 Earl Jones Way • Louisville, KY 40299 • 800-626-1126 • rev-a-shelf.com

PAGE 1
Congratulations! You have purchased the finest carousel product available, the Lazy Daisy® Susan. For any questions or further information, please contact us at: BY 1255 Way South Park Dr.,KY Kernersville, NC 27284,• USA 12400 Earl Jones • Louisville, 40299 • 800-626-1126 rev-a-shelf.com Telephone 336-996-7774, 1-800-222-6941, Fax 336-996-1812 Website: www.petermeier.com Email: info@petermeier.
PAGE 2
of 4
PAGE 3
System 9 Pie-cut Doors revolving 90-degree corner Mounting Instructions 1. Mount bottom mounting bracket to base of cabinet using template provided. 2. Drill pilot holes for top mounting bracket using template provided. 3. Prepare top and bottom trays by inserting tray cover caps. 4. Insert top and bottom tray positioning caps. (Make sure that the slot in the bottom of the cap faces the 90-degree cutout of the tray). 5. Insert top of tube (end without hole) through bottom of one tray. 6.
PAGE 4
System 9 Pie-cut Doors revolving 90-degree corner Door Adjustment 1. Door alignment - Open doors so that one side of the bottom mounting bracket can be seen. With a pencil, mark the original position of the bottom mounting bracket. Insert a screw into the large hole on the end of the bracket (When inserting the screw, place it off-center in the direction of desired adjustment). Take out the original fixing screw. Repeat on the other side.