Installation Sheet

INSTALLATION INSTRUCTIONS: GLIDEWARE GLD SERIES 3
Transfer Dimension B to center
of the back cabinet. Mark this
location with a 6” wide, level line
(See Figure 3).
STEP 3
Make a center mark on the front of
the unit (See Figure 6).
Figure 3
6”
Measurement B
Measurement B
Pre-drill
Mark center
Mark center
3
32
Mark the bottom center of
mounting bracket (See Figure 4).
STEP 4
Figure 4
Figure 5
Figure 5A
Figure 6
Center mounting bracket along
line drawn in step 3. Pre-drill (2)
holes in back of cabinet using
mounting bracket as template with
a 3/32” drill bit (See Figure 5).
Place the mounting bracket on
the back of the cabinet. Align the
bottom of the mounting bracket
with the horizontal line that was
made in step 3. Use (2) 1-1/4”
screws to fasten the mounting
bracket to the back of the cabinet.
Attach soft-close cover as seen in
gure 5A (soft-close units only).
STEP 5
STEP 6