Installation Instructions

Tresco Lighting by Rev-A-Shelf
12400 Earl Jones Way
Louisville, KY 40299
Tel: [phone]
Fax: [phone]
Email: [e-mail]
Web: www.trescolighting.com
Installation Instructions: EquiLine FREEDiM Wireless Dimmers
Single Zone • 12VDC 60W & 24VDC 96W
Page 2
51mm
2”
51mm
2”
51mm
2”
106mm
4-3/16”
46mm
1-25/32”
11.5mm 7/16”
10mm
13/32”
10mm
13/32”
51mm
2”
DIMENSIONS:
Save these instructions for future reference.
For technical assistance, call 1-800-227-1171
I-EQW1REC-1221
PowSupIn/116/grx
IMPORTANT SAFETY INSTRUCTIONS
CAUTION: To reduce the risk of re, electric shock, or injury to persons:
• Route and secure cords so they will not be pinched or damaged.
• Use only insulated staples or plastic ties to secure ALL loose cords.
• Replace battery with a CR2032 battery only. Not rechargeable.
• Use Class 2 or LPS, 12VDC or 24VDC Power Supply to power the Receiver.
• 12VDC 60W 5A max or 24VDC 96W 4A max Receiver output.
• Use only in dry locations. Not for use where exposed to the weather
• The Receiver is not intended for recessed installation in ceilings or softs.
• A licensed electrician should be consulted for wiring through ceilings,
softs, or walls.
• All wiring must follow NEC regulations.
Pairing Button
Programming Instructions:
Installing Wireless Dimmers:
Mount using 3M
™
Tape
1. Remove the insulation sheet from the battery compartment.
2. Fix the magnet onto the surface with 3M
™
tape (provided).
3. Mount the Wireless Dimmer onto the surface with the magnet.
Note: The 3M
™
adhesive is pressure sensitive tape. Pressure must be applied in order for
proper adhesion to take place. Not intended for rough or raised surfaces.
Mount using Screw
1. Remove the insulation sheet from the battery compartment.
2. Fix the magnet onto the surface with small screw (provided).
3. Mount the Wireless Dimmer onto the surface with the magnet.
Light quickly ashes when the battery is low.
1. Slide out the battery tray.
2. Change with a new CR2032 cell battery.
Battery Tray
Magnet with
3M tape
Magnet
with screw
REPLACE BATTERY:
Note: Only one Receiver and one Dimmer can be paired. You cannot
program for multiple Receivers and Dimmers.
PAIRING
• Press once (do not hold down) the Pairing Button on the Wireless
Dimmer within 3 seconds after the Receiver is connected to the
power supply. It's successfully paired when the output light
ashes. The easiest way to do this is to remove the dimmer from
the mounting location and hold it in one hand and apply power to
the power supply with the other.
UNPAIRING
• Long press (over 3 seconds) the pairing button on the Wireless
Dimmer within 3 seconds after the Receiver is connected to the
power supply. It's successfully unpaired when the output light
ashes.
Signal Interference:
Outside interference may affect the signal between the Dimmer and
Equiline Receiver. Typical items that might cause interference include:
metal pots and pans, leaded glass, aluminum framed doors, etc. If
experiencing interference, try repositioning the devices in 6” (15cm)
increments. This typically allows the system to function properly.