Installation Guide

Customer Service: 800-626-1126 | rev-a-shelf.com
4
Attach the telescoping
handle to the hanging
rod and the plastic handle
endcap to the telescoping
handle using M3.5 screws
(See Fig. 8).
STEP 8
Pull down the left and
right arms to attach the
hanging rod assembly to
the pull-down unit. Using
the (2) provided M8 hex
bolts and allen wrench,
attach the plastic endcap
to the end of each arm
(See Fig. 9A).
Note: The telescoping
hanging rod can be
extended by twisting to
unlock and twisting back
to lock into place (See
Fig. 9B).
For 12” depth
closet systems, it is
recommended but not
necessary to install the (2)
provided bumpers
(See Fig. 10).
STEP 9
STEP 10
12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service: 800-626-1126
FIGURE 8
FIGURE 9A
FIGURE 9B
FIGURE 10
3
Using the provided wood screws, install all of
the (A) screws except the last (3) in the front.
Install the heavy duty stop as shown using the
provided screws that were
included.
NOTE: this unit comes
with (2) standard bumpers that
are not used in this installation.
4
Attach the pull-down rod to the
hanging rod and the plastic handle to
the pull-down rod using the (B) screws.
6
Repeat step 4 for other side.
(Note: it is very important that
both pull-down assemblies are
lined up correctly with each other to
ensure proper function.
5
7
Pull down the left and right arms to attach the hanging rod
assembly to the pull-down unit. Using the (2) provided hex
bolts (C) and allen wrench attach plastic endcap to the end of
each arm as shown.
Note the hanging rod can be extended by
twisting motion to unlock and twisted back to lock into place.
For 12” depth
closet system, it
is recommended
but not necessary
to install the (2)
provided rubber
bumpers as shown.
3
Using the provided wood screws, install all of
the (A) screws except the last (3) in the front.
Install the heavy duty stop as shown using the
provided screws that were
included.
NOTE: this unit comes
with (2) standard bumpers that
are not used in this installation.
4
Attach the pull-down rod to the
hanging rod and the plastic handle to
the pull-down rod using the (B) screws.
6
Repeat step 4 for other side.
(Note: it is very important that
both pull-down assemblies are
lined up correctly with each other to
ensure proper function.
5
7
Pull down the left and right arms to attach the hanging rod
assembly to the pull-down unit. Using the (2) provided hex
bolts (C) and allen wrench attach plastic endcap to the end of
each arm as shown.
Note the hanging rod can be extended by
twisting motion to unlock and twisted back to lock into place.
For 12” depth
closet system, it
is recommended
but not necessary
to install the (2)
provided rubber
bumpers as shown.