Installation Guide

INSTALLATION INSTRUCTIONS: CPDR SERIES PULL-DOWN CLOSET ROD 3
FIGURE 5
Afx the arm stop bracket
using the provided screws
(See Fig. 7).
Note: There is a left and
right arm stop bracket.
Remove guide block and
repeat steps 1-7 to install
the other arm.
From the bottom of the
screw, attach (1) of the
8-32 nuts to secure the
screw and the bumper to
the arm stop bracket (See
Fig. 6).
Place (1) of the provided
8-32X50 Phillips Head
screws into the opening
(See Fig. 5).
STEP 4
STEP 5
STEP 6
STEP 7
Place the bumper on the
arm stop bracket (See Fig. 4).
Note: This unit comes
with two standard
bumpers that are not
used in this installation.
FIGURE 4
FIGURE 6
FIGURE 7