Installation Guide

Customer Service: 800-626-1126 | rev-a-shelf.com
2
X
X
X
Measure at least 34-3/4”
(882.7mm) from the top
of your closet panel. By
using the guide block and
dowels, this will provide
a platform to ensure both
arms are even on both
sides (See Fig. 1).
STEP 1
If you are installing into a
12” or 14” depth closet
you will install the pull-
down arm assembly to the
front edge of the closet
panel as shown. (See Fig.
2A)
For all other closet depths
(16” and 20”) you will
install at least 14” from
the rear of the closet. (See
Fig. 2B)
STEP 2
FIGURE 1
FIGURE 2A FIGURE 2B
34
3
/4”
(882.7mm)
MINIMUM
GUIDE BLOCK
12”, 14” DEPTH 16”, 20” DEPTH
GUIDE BLOCK
14” MINIMUM
GUIDE BLOCK
FRONT FRONT
Using the provided at
head wood screws, install
all of them except the last
three front screws (See
Fig. 3).
STEP 3
FIGURE 3