Use and Care Manual

ManualsBrandsRev-A-Shelf ManualsGarage StorageSidelines 14 in. Chrome Pop Out Deluxe Belt and Tie Rack

INSTALLATION INSTRUCTIONS: POP OUT BELT RACK / TIE RACK`

10 MIN

ESTIMATED ASSEMBLY TIME:

CARE AND MAINTENANCE:

Clean with a damp cloth and wipe

parts dry.

* Dependent on unit purchased

TOOLS REQUIRED:

WATCH TUTORIALS OF OUR

PRODUCTS BEING INSTALLED

WWW.REV-A-SHELF.COM/VIDEOS

12400 Earl Jones Way

Louisville, KY 40299

rev-a-shelf.com

Customer Service: 800-626-1126

POP OUT BELT RACK / TIE RACK

PARTS LIST

No. Description Qty.

A Pop Out Belt Rack / Tie Rack* 1

B #8 - 32 X 1/2” Wood Screws 2

C M6 X 6MM Euro Screws 2

B C

I-XRCPOSL-0721

#2#2#2

Summary of content (4 pages)

PAGE 1
2400 Earl Jones Way Louisville, KY 40299 rev-a-shelf.com Customer Service: 800-626-1126 POP OUT BELT RACK / TIE RACK TOOLS REQUIRED: 1 8 #2 ESTIMATED ASSEMBLY TIME: 10 MIN PARTS LIST No. Description Qty. A Pop Out Belt Rack / Tie Rack* 1 B #8 - 32 X 1/2” Wood Screws 2 C M6 X 6MM Euro Screws 2 * Dependent on unit purchased CARE AND MAINTENANCE: Clean with a damp cloth and wipe parts dry. A B C WATCH TUTORIALS OF OUR PRODUCTS BEING INSTALLED WWW.REV-A-SHELF.
PAGE 2
FIG. 1 STEP 1 Determine which direction the unit is being mounted. If the rack needs to switch directions, unscrew the 2 screws that attach the rack to the pop out mechanism. Reverse the rack to the desired direction and secure it back onto the pop out mechanism. (See Figure 1). Screws Screws #2 STEP 2 Use (2) M6 x 6 mm Euro Screws if using the system holes to secure the deluxe sliding rack to the cabinet (See Figure 2A).
PAGE 3
12400 Earl Jones Way Louisville, KY 40299 rev-a-shelf.com Customer Service: 800-626-1126 INSTRUCCIONES DE INSTALACIÓN / INSTRUCTIONS D’INSTALLATION COLGADOR PARA CINTURÓN O CORBATAS EMERGENTE SUPPORT DE CEINTURE / CRAVATES RÉTRACTABLE Herramientas requeridas: Outils Requis: 1 8 #2 Tiempo estimado de ensamblado: Durée de l’installation: 10 MIN CUIDADO/ ENTRETIEN: Lista de Partes / Liste des Piéces No. Descripción / La description Qty.
PAGE 4
PASO 1 / ÉTAPE 1 FIG. 1 Determine en qué dirección se monta la unidad. Si el colgador necesita cambiar de dirección, desatornille los 2 tornillos que sujetan el colgador al mecanismo emergente. Invierta el colgador en la dirección deseada y fíjelo de nuevo en el mecanismo emergente. (Vea la figura 1). Déterminez dans quel sens l’unité doit être montée. Si le support doit changer de direction, dévissez les 2 vis qui fixent le support au mécanisme d’extraction.