Installation Instructions

6) Lay one of the trays on the sink panel while making sure that the top of the tray lines up with the (2) marks you made in step 5.

Once lined up, using a pencil, mark in the center of the hole as shown.

7) Now that all holes are marked, using a 3/32 drill bit, carefully drill all of the marked locations.

Be very careful to NOT drill thru your panel.

4) Using the provided extension template, carefully remove from the hinge template. Align the corner of the extension template to the right

corner of your sink front panel. Using the pencil mark your hole locations and repeat for the left side of the sink front panel. You will then

repeat step 4 if you have another sink front panel.

5) Now take the hinge template and turn on its side. Using a pencil mark the left and right top indents.

This will locate where your trays will mount.

Bottom left and right of sink front panel

Top of Panel