Instructions / Assembly

3
⁄”
[20mm]
⁄”
[20mm]
2
⁄”
(54mm)
6
⁄”
(160mm)
2
⁄”
(54mm)
6
⁄”
(160mm)
9 ⁄”
(246mm)
Center line of cabinet
For 24” unit For 36” unit
15 ⁄”
(396mm)
9 ⁄”
(246mm)
For 24” unit For 36” unit
15 ⁄”
(396mm)
INSTALLATION INSTRUCTIONS: 5PD SERIES PULL DOWN
Attach the two wire baskets to
the side frames using qty (8)
M5x8 pan head machine screws
as shown in gure 3. Note:
Screws may already be attached
to brackets.
Attach the handle to the side
frames using qty (2) M5x8 pan
head machine screws as shown
in gure 4. Note: Screws may
already be attached to handle.
Mount this assembly to the
bottom mount brackets. The
rear of the side frames will slide
over a pin on the bottom mount
brackets. Qty 4 M4x6 pan head
screws are used in the front only
as shown in Fig. 5.
NOTE
Screws will have to be removed
from wire basket ends rst.
Same screws are then used to
attach.
STEP 3
Attach the two cover plates to
the side frames to cover the
screws installed in Fig. 5.
STEP 4
Assembly
FIG.
3
FIG.
5
FIG.
4
#4 M5x12 Machine screws
#6 M4x6 machine head screws
Remove the screws which are already fastened to
Part E (handle)
D
C
F
4
#2
#2