Installation

INSTALLATION INSTRUCTIONS: 5LB SERIES LEGRABOX WASTE CONTAINER 3
Use the measurements (See
Fig 5) to mark the door
mounting hole locations with
your awl and rubber mallet.
STEP 5
Place the Rev-A-Shelf logo
caps on both sides of the
LEGRABOX (See Figure 4).
STEP 4
Install the door brackets to
your door with the #6 x 1/2”
screws included with the RV
Door Mount screw pack
(See Fig 6).
NOTE: Make sure not to drill
through your door.
NOTE: Each pack contains
2 extra screws. Discard any
extras you don’t need.
STEP 6
Align the door brackets with
locks on the front of the
LEGRABOX frame and push
until engaged (See Fig 7). You
will again hear a “click” sound.
STEP 7
FIGURE 5
FIGURE 6
FIGURE 7
#2
51MM + OVERLAY
51MM + OVERLAY
315MM - SINGLE WASTE CONTAINER WIDTH
391MM - DOUBLE WASTE CONTAINER WIDTH
32MM
32MM
14MM + OVERLAY
14MM + OVERLAY
32MM
32MM
32MM
32MM
96MM
96MM
FIGURE 8
REMOVE CAP
REMOVE CAP
If your drawer needs to
be adjusted to t the door
properly, rst remove the
cover caps (See Fig 8).
STEP 8
Finding The Overlay
The overlay equals the door
height minus the cabinet
opening height divided by 2.
For example, if a door is
660MM tall, and the cabinet
opening is 610MM tall:
660-610=50
50/2 = 25
The overlay = 25MM
FIGURE 4