Installation

Customer Service: 800-626-1126 | rev-a-shelf.com

Use the measurements (See

Fig 1) to mark the slide

mounting hole locations. It’s

recommended to use an awl

and rubber mallet for this step.

NOTE: If you are installing

into a face frame cabinet,

you will need to scab out the

sidewall of the cabinet so

that it’s ush with the face

frame opening.

STEP 1

Install slides in your cabinet

using #8 x 1/2” screws found

in slide mount screw pack 5LB

(See Fig 2).

STEP 2

Place the frame on the slide

at an angle (See Fig 3.1). Push

back until you hear a “click”

sound (See Fig 3.2).

STEP 3

FIGURE 1

FIGURE 2

FIGURE 3.1 FIGURE 3.2

ALL HOLES ARE

38MM FROM

CABINET FLOOR

INSERT AT AN ANGLE

PUSH UNTIL YOU HEAR A ”CLICK”

37MM

38MM

69MM

293MM

357MM

HOLE

LOCATIONS

NOTE: THE BELOW STEPS SHOW INSTALLATION INTO A FRAMELESS CABINET. IF INSTALLING INTO

A FACE FRAME CABINET, YOUR CABINET SIDE WALLS WILL NEED TO BE MADE FLUSH WITH THE

FACE FRAME USING A SCAB BOARD. CABINET OPENING DIMENSIONS REMAIN CRITICAL.