Installation Guide

Customer Service: 800-626-1126 | rev-a-shelf.com

Use the measurements from

Figure 1 to mark the slide

mounting hole locations.

(recommended with an awl and

rubber mallet).

NOTE: If installing into a face

frame cabinet, the cabinet

side walls will need to be

made ush with the face

frame using a scab board.

STEP 1

Install slides in your cabinet

using #8 x 1/2” screws found

in 5LB slide mount screw pack

(See Fig 2).

STEP 2

Place the frame on the slide at

an angle and then lay at (See

Fig 3.1). Push back until you

hear a “click” (See Fig 3.2).

STEP 3

FIGURE 1

FIGURE 2

FIGURE 3.1 FIGURE 3.2

ALL HOLES ARE

1-1/2” (38 mm)

FROM CABINET

FLOOR

INSERT AT AN ANGLE

PUSH UNTIL YOU HEAR A ”CLICK”

1-15/32”

(37 mm)

1-1/2”

(38 mm)

2-23/32”

(69 mm)

14-1/16” (357 mm)

HOLE

LOCATIONS

NOTE: THE BELOW STEPS SHOW INSTALLATION INTO A FRAMELESS CABINET. IF INSTALLING INTO

A FACE FRAME CABINET, YOUR CABINET SIDE WALLS WILL NEED TO BE MADE FLUSH WITH THE

FACE FRAME USING A SCAB BOARD. CABINET OPENING DIMENSIONS REMAIN CRUCIAL.

11-17/32” (293 mm)