Instructions / Assembly

ManualsBrandsRev-A-Shelf ManualsKitchen18 in. H x 11.75 in. W x 22 in. D Pull-Out Two-Tier Base Cabinet Cookware Organizer with Soft-Close Slides

INSTALLATION

INSTRUCTIONS

TOOLS REQUIRED:

ESTIMATED ASSEMBLY

TIME:

30 MIN

CARE AND

MAINTENANCE:

Clean with a damp cloth

and wipe parts dry.

(4)

3/4” Wood Screws

(16)

Machine Screws

(3)

1/2” Wood Screws

1 Qt.

Adjustable Rear

Mounting Bracket

(2)

U-Shaped Support Brackets

(2)

Wire Brackets with Slides

(4)

3/4” Wood Screws

(16)

Machine Screws

(3)

1/2” Wood Screws

1 Qt.

Adjustable Rear

Mounting Bracket

(2)

U-Shaped Support Brackets

(2)

Wire Brackets with Slides

(2)

U-Shaped Support Brackets

(2)

U-Shaped Support Brackets

(1)

Lower Slide Basket

(1)

Lower Slide Basket

(2)

Handlebar

(1)

Handlebar

(1)

Upper Slide Basket

(1)

Upper Slide Basket

(14)

Dividers

(7)

Dividers

Parts List:

2400 Earl Jones Way • Louisville, KY 40299

(800) 626-1126

www.rev-a-shelf.com

I-CO/5CW2SC-0614

(4)

3/4” Wood Screws

(4)

3/4” Wood Screws

(16)

Machine Screws

(16)

Machine Screws

(5)

1/2” Wood Screws

(5)

1/2” Wood Screws

CO-21C-2-5

Part #

CO-15C-2-5

Part #

5CW2-2122-CR

5CW2-1222-CR

Note 1: Be sure to measure cabinet opening and basket width to make sure basket will clearly pull-out

of the cabinet without interference.

Note 2: All cabinets are built and constructed dierently, some have a built-in shelf that is not easily removeable. This organizer

can still be installed with the shelf in place, but note some taller items could hit the shelf when opening and closing.

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS 2400 Earl Jones Way • Louisville, KY 40299 (800) 626-1126 www.rev-a-shelf.com TOOLS REQUIRED: ESTIMATED ASSEMBLY TIME: CARE AND MAINTENANCE: 30 20 MIN Clean with a damp cloth and wipe parts dry.
PAGE 2
1) Begin by removing the slides from the upper and lower slide basket. (Note: in order to do so, you will need to press the black triggers on both sides of the basket to remove.) 2) Attach the pair of bottom basket slides to the bottom hole position into the U-shaped Support bracket using (8) of the provided machine screws. (Note: start with the circular hole first and then proceed to the slotted hole next.) 3) Attach the pair of upper basket slides to one of the (3) height options and repeat step (2).
PAGE 3
5) Using the provided from the opening. ½” wood screw, attach slide to face frame of cabinet while making sure that the front of the slide is ¼” back 1/4” (Note: if installing into a frameless application you can simply use the same ½” screw and install into the side wall of the cabinet.) 6) Use the (4) ¾” wood screws to attach U-shaped supports into floor of the cabinet. 7) Push the (2) rear metal sockets to the rear of the cabinet and attach both sides using the (2) ½” wood screws.
PAGE 4
An optional Door Mount Kit (Sold Separately) will attach your cabinet door to your Rev-A-Shelf® product.
PAGE 5
Instrucciones de instalación Les instructions d’installation 2400 Earl Jones Way • Louisville, KY 40299 (800) 626-1126 www.rev-a-shelf.
PAGE 6
1) Comience por remover los rieles de la parte superior e inferior del riel de la canasta. (Note: in order to do so, you will need to press the black triggers on both sides of the basket to remove.) 1) Retirez les coulisses du panier de la coulisse du haut et du bas. Remarque: Pour ce faire, vous devrez appuyer sur les déclencheurs noirs sur les deux côtés du panier pour les retirer.
PAGE 7
5) Utilizando el tornillo de madera de ½” proveído, sujete el deslizante al marco de la cara del gabinete mientras se asegura de que el frente del deslizante esta a ¼” atrás de la apertura. Nota: si está instalando dentro de una aplicación sin marco, usted simplemente puede utilizar el mismo tornillo de ½” e instale dentro del deslizante lateral de la pared del gabinete. canastas no interfieran con las bisagras de la puerta del gabinete. 1/4” 5) En utilisant la vis à bois de ½” (12.
PAGE 8
Un juego opcional para montaje de puerta (se vende por separado) podrá sujetar la puerta del gabinete a su producto Rev-A-Shelf®. Les charnières ont des trous rainurés si vous avez besoin d’effectuer un micro-réglage du panneau de l’évier vers la gauche ou vers la droite.