Instructions / Assembly

INSTALLATION INSTRUCTIONS: 5300/5700 SERIES PULLOUT PANTRY 5
To determine the door
mounting position, rst
calculate the overlay. Refer to
Figure 9 for more direction.
NOTE: Overlay is the door
width minus the cabinet
opening width, divided by
2. For example, if a door is
12-1/2” wide, and the cabinet
opening is 12” wide:
12-1/2 - 12 = 1/2
1/2 divided by 2 = 1/4
The overlay = 1/4”
Finding Measurement “B”
Lay your door on a at surface
and mark (6) or (8) pilot hole
locations based on Figure 9.
Dimension “B” for a face frame
cabinet is 4-1/4”. Use an 1/8”
drill bit to pre-drill holes.
STEP 10
FIGURE 9
-
-
(57)
A
D
B
Use table to nd dimensions “C” and “D”
Finding Measurement “A”
Locate your stiles
(Note: Screws need to be installed
into the thick portion of your door
to prevent splitting) Adjust the top
T-Type door mount brackets so they
will hit the mounting screws in this
dimension
8" 10" 14" 16" 20"
A 7.87[200] 9.84[250] 13.86[352] 15.87[403] 19.88[505]
B 7.09[180] 9.06[230] 13.07[332] 15.08[383] 19.09[485]
C 8.82[244] 10.97[274] 13.82[351] 16.81[427] 20.83[529]
D 11.1[282] 13.07[332] 16.1[409] 19.09[485] 23.11[587]
B = Center to Center
A = Outside to Outside
C = Min. Bracket to Bracket
D = Max. Bracket to Bracket
B C
D
5743 4” [102 mm] + overlay N/A N/A
5750 4” [102 mm] + overlay 20-7/8” [530 mm] N/A
5758 4” [102 mm] + overlay 20-7/8” [530 mm] 20-7/8” [530 mm]
5773 4” [102 mm] + overlay 20-7/8” [530 mm] 25-3/16” [640 mm]
1
8