Installation

FACE FRAME CABINETS
Install bottom slide
1) Attach feet (#9) to bottom slide (C) using M4 screw (#8) as shown
in
1. To attach the rear foot, the soft-close will need to be
to remove the inner member(s) from the slide so you have a hollow
channel when attaching the feet.
Install top slide
3) The top slide (B) of the pantry needs to be mounted with the
face frame. It will likely be necessary to cut and attach a spacer board
as shown in
3.
Insert pantry frame
5) The bottom of the frame (A) sits on top of the bottom slide (C) as
shown in 5. Use M6 screw (#2) and washer (#3) to attach.
6) Slide the top portion of the frame up so that the top slide is
concealed but not touching the wood cabinet.
7) Two pins in top slide (B) insert into mating bushings in the top of
the frame (A) as shown in
6.
8) Tighten the two screws in 7.
C
B
C
B A
UNIT : inch (mm)
3
Top Spacer
Must be with Face Frame
4) Using 4, mark 3 hole locations and drill ⁄ ” pilot holes.
Roughly align the front of the slide with the front of the face frame
and center the slide in the cabinet. Attach to the spacer board from
step 3 using screws (#6).
2) Mark 8 hole locations and drill ⁄ ” pilot holes. Roughly align the
front of the slide with the front of the face frame and center the slide
in the cabinet. Attach to the using screws (#7). When using the
template to align the pilot hole, be sure to fold across the dotted line
on the front of the template to wrap over the face frame or front end
of the frameless cabinet. This will keep your slide from being installed
too far back into the cabinet. See 2.
A
C
A