Installation Guide

INSTALLATION INSTRUCTIONS: 5730/5786 SERIES PULLOUT BASKET WITH SOFT–CLOSE

12400 Earl Jones Way

Louisville, KY 40299

rev-a-shelf.com

Customer Service: 800-626-1126

5730/5786 SERIES PULLOUT BASKET WITH SOFT-CLOSE

TOOLS REQUIRED:

30 MIN

ESTIMATED ASSEMBLY TIME:

CARE AND MAINTENANCE:

Clean with a damp cloth and

wipe parts dry.

I-57XX-0915

Datum point

Bottom dimension

12CR /15CR / 21CR / 30CR / 33CR

210 / 8

”

164

/ 241

/ 393

/ 623

/ 699

F G

”

(5730)

(5786)

Basket (A), Slide (B), Side mount bracket (C), Bottom Mount bracket (D), Logo cap (E), Mounting

bracket (F), Door mounting bracket (G), Double sided tape (H), wood screw (I), Machine screw (J)

PART LIST:

PAGE 1
2400 Earl Jones Way Louisville, KY 40299 rev-a-shelf.com Customer Service: 800-626-1126 5730/5786 SERIES PULLOUT BASKET WITH SOFT-CLOSE TOOLS REQUIRED: #2 7 64 ESTIMATED ASSEMBLY TIME: PART LIST: 30 MIN B A (5786) A (5730) CARE AND MAINTENANCE: C Clean with a damp cloth and wipe parts dry.
PAGE 2
/ mm /” 1 2 6 1 2 ” 9 ” 1 /2 64 5 17 / ” 1 64 24 17 / 27 Mounted: / 699 R mm I mm Bottom dimension 2” t mm /32 / 89 21 poin A (5786) 0 A (5730) B m /3 mm B m um E 40 Dat 15 Attach bottom-mount brackets to front and rear of each slide 1 2C with two screws per bracket.164 / 2R41/15CR / 21C / 393 R / 30C Front bracket should use the / 623 R / 33C ” / 699 R 2 / ” fourth and sixth top hole61from 1 /2 ” 9 1 /2 4” 6 the front of the slide.
PAGE 3
12 164m CR /15C m/ 241m R / 21C m/ 393m R / 30CR m/ 623m / 33CR Flank Dimension m/ ” 699m 1 /2 m For Face-Frame Cabinets 2” Side Mounted: Place slide assembly on top of cabinet mount bracket, insert screws, adjust to the desired width of basket and tighten screws. Repeat on opposite wall.
PAGE 4
64” 117/ ” m 65/16mm 32m 64” ”117/ m 160 m 2 3 mm 125/ 64 35 Side Mounted Without Brackets: STEP1 k Bac 49 64” 1 / min45mm Wall Dimension J t ron F Frameless cabinets and scabbed Face Frame cabinets only Attach slide half of side mount bracket to front of slide with two screws per slide. Front screw should use the fourth top hole from the front of the slide.